i bought the mendel90 complete kit. didnt have any problems with it till today:
because i had problem with abs sticking to the heated bed i bought some blue masker tape and some white pe tape. the masker tape worked nice, i printed a 5 L x 30 l x 15 H mm box and it sticked very well.
i left the printer doing its job and at some point i heard some wierd noises. running there i saw that the head ripped the maskers tape off the heated bed. i turned it off, let it cool down for a while after this i found that the brass ending of the jhead got torn of the rest of the body and was sitting at a 90 degrees angle than it was suposed to. the tube is filled with abs and cant see if the thread in it is broken as well, but with that much abs there i cant do anything to repair it.
what is a good source of jheads for europe, i saw the link for the jhead sources but i want to be sure i'm buying the right one.
if i buy a new one should i make any changes regardin the temperature readings?
can i buy one directly from nophead???
HELP :(
because i had problem with abs sticking to the heated bed i bought some blue masker tape and some white pe tape. the masker tape worked nice, i printed a 5 L x 30 l x 15 H mm box and it sticked very well.
i left the printer doing its job and at some point i heard some wierd noises. running there i saw that the head ripped the maskers tape off the heated bed. i turned it off, let it cool down for a while after this i found that the brass ending of the jhead got torn of the rest of the body and was sitting at a 90 degrees angle than it was suposed to. the tube is filled with abs and cant see if the thread in it is broken as well, but with that much abs there i cant do anything to repair it.
what is a good source of jheads for europe, i saw the link for the jhead sources but i want to be sure i'm buying the right one.
if i buy a new one should i make any changes regardin the temperature readings?
can i buy one directly from nophead???
HELP :(